rightpure.blogg.se

Honda crv oil changes
Honda crv oil changes








  1. Honda crv oil changes install#
  2. Honda crv oil changes drivers#

Select 'A' if you just did an oil change. Hold the enter button for at least 15 seconds and you should be met by a screen asking you what to reset. Press okay the oil life should display as a percentage. Push this button until some options show on screen then use the side arrows to navigate to the wrench icon Check oil level again after running and adjust accordingly If the oil light doesn't turn off along with the other lights then shut the engine off and double check your oil filter and drain plug Cap the oil and be sure the dipstick is back in then start the car and count to 10, be sure the oil light on the dash goes off along with the rest of the lights after startup. The difference between the two lines on the dipstick is ~ 1 liter, additional the top line the arrow is pointing to is the full mark. Fill the oil using the funnel in the oil fill in the engine bay, start with 4L of oil and then check the dipstick Clean off the bottom of the car with a rag and optional brake clean then reinstall the skid plate

Honda crv oil changes install#

As hard as you can tighten it by hand is good, do not use the oil filter pliers to install the filter Get your new oil filter and use some of the old oil to lubricate the o-ring on the top of the filter before screwing in by hand. Be careful as there will be oil draining out of the filter as you take it off Loosen the oil filter using the oil filter pliers and remove the oil filter. Be sure that you still have the crush washer on the bolt when you tighten it down. Once the oil has stopped being a steady stream and begins to drop put the drain plug back and tighten until it begins to resist and then go another 1/4 turn. Put your drain pan under the oil drain plug and use the 17mm wrench/ratchet to release the plug and empty the oil into the drain pan (pay careful attention to which bolt you loosen as the engine mount is very near the drain bolt and is also a 17mm) The flathead screws only need to be turned 90° and they will release Remove the skid plate using a Phillips head screwdriver and a Flathead Raise and support the vehicle as outlined by the owners manual, only use the designated jacking points. Remove oil fill cap and prop funnel in oil fill additionally pull the dip stick out about one inchĭo these steps now to ensure that the oil fill cap will come off and the dipstick will come out without breaking (nothing worse than draining a fluid to find out you can't refill) You should feel a plastic tab, push it to the right while pulling hood up and prop the hood up Proceed with opening the hood the rest of the way with the release located underneath the middle of the hood.

Honda crv oil changes drivers#

Open hood with hood release located to the left of the drivers footwell.










Honda crv oil changes